Bootstrap procedures for detecting multiple persistence shifts in heteroskedastic time series

This article proposes new bootstrap procedures for detecting multiple persistence shifts in a time series driven by non-stationary volatility. The assumed volatility process can accommodate discrete breaks, smooth transition variation as well as trending volatility. We develop wild bootstrap sup-Wald tests of the null hypothesis that the process is either stationary [I(0)] or has a unit root [I(1)] throughout the sample. We also propose a sequential procedure to estimate the number of persistence breaks based on ordering the regime-specific bootstrap p-values. The asymptotic validity of the advocated procedures is established both under the null of stability and a variety of persistence change alternatives. A comparison with existing tests that assume homoskedasticity illustrates the finite sample improvements offered by our methods. An application to OECD inflation rates highlights the empirical relevance of the proposed approach and weakens the case for persistence change relative to existing procedures.     

Room Temperature Ferromagnetism in Co-doped CuAlO2 Nanofibers Fabricated by Electrospinning

One-dimensional, diluted magnetic semiconductor nanofibers have attracted increasing attention for their unique magnetic properties, large specific surface area, and high porosity. These qualities lead to excellent performance in magneto-optical devices, magnetic resonance imaging, ferrofluids and magnetic separation. The purpose of this study is to fabricate P-type one dimensional CuAlO2-based diluted magnetic semiconductor nanofibers. First, we fabricated Cu Al0.95Co0.05O2 nanofibers with an average diameter of 1 μm with the electrospinning method. The annealed nanofibers were thermally treated at a temperature of 1 100 ℃ and then shrunk to a diameter of about 650 nm. We used X-ray diffraction measurements and Raman spectra to confirm that the Cu Al0.95Co0.05O2 nanofibers had a single impurity free delafossite phase. The X-ray photoelectron spectroscopy analysis indicates that Co was present in the +2 oxidation state, resulting in an room temperature ferromagnetism in the Cu Al0.95Co0.05O2 fiber. This contrasts with nonmagnetism in pristine CuAlO2 fiber. The coercivity(Hc) value of 65.26 Oe and approximate saturation magnetization(Ms) of 0.012 emu/g demonstrate good evidence of ferromagnetism at room temperature for Cu Al0.95Co0.05O2 nanofibers.     

Hopping transport in the space-charge region of p-n structures with InGaN/GaN QWs as a source of excess 1/f noise and efficiency droop in LEDs

Semiconductors - It is shown that the emission efficiency and the 1/f noise level in light-emitting diodes with InGaN/GaN quantum wells correlate with how the differential resistance of a diode...     

AP1000稳压器波动管竖直管段空气-水CCFL实验研究

使用竖直管代替波动管模型开展稳压器波动管竖直管段内空气-水两相逆流限制（CCFL）特性可视化实验研究。实验现象表明:竖直管与上容器接口处的局部CCFL决定了进入竖直管内的液相流量；竖直管内的局部CCFL决定了从竖直管流出的液相流量；两处局部CCFL均随空气流量的增大而增强。在较低气量情况，进入竖直管内的液相能够完全或大部分流出，竖直管内的局部CCFL较弱，上容器和竖直管接口处的局部CCFL在整体CCFL中占主导地位，整体CCFL程度随着上容器液位升高而略有增强。在高气量情况，从上容器进入竖直管的液相大部分或者完全被限制而不能向下流出，竖直管内的局部CCFL强烈，在整体CCFL中占主导地位，整体CCFL特性不受上容器液位变化的影响。通过实验数据拟合得到了新的稳压器竖直管CCFL模型。稳压器波动管CCFL数据和稳压器竖直管CCFL数据基本重合，表明波动管CCFL主要由CCFL-U决定。      

基于哈希链的软件定义网络路径安全

针对软件定义网络中，控制器无法保证下发的网络策略能够在转发设备上得到正确执行的安全问题，提出一种新的转发路径监控安全方案。首先以控制器的全局视图能力为基础，设计了基于OpenFlow协议的路径凭据交互处理机制；然后采用哈希链和消息验证码作为生成和处理转发路径凭据信息的关键技术；最后在此基础上，对Ryu控制器和Open vSwitch开源交换机进行深度优化，添加相应处理流程，建立轻量级的路径安全机制。测试结果表明，该机制能够有效保证数据转发路径安全，吞吐量消耗比SDN数据层可信转发方案（SDNsec）降低20%以上，更适用于路径复杂的网络环境，但时延和CPU使用率的浮动超过15%，有待进一步优化。     

In situ characterization of LiY(WO4)2 nanotubes for electrochemical energy storage

Here, LiY(WO₄)₂ nanotubes are prepared via a feasible electrospinning technique. This new anode material shows excellent electrochemical properties. The capacity loss of LiY(WO₄)₂ nanotubes is as low as 6.9% after 156 cycles, while bulk LiY(WO₄)₂ presents the capacity loss higher than 55.0%. Even after 600 long-life cycles, the capacity loss of the nanotubes is only 9%. It can be seen that the hollow structure with a rough surface and a porous morphology contributes to the improvement of electrochemical performance. Furthermore, online X-ray diffraction (XRD) method is firstly applied to understand the lithium ions insertion/extraction mechanism of LiY(WO₄)₂ nanotubes. It can be concluded that it is an asymmetrical two-phase reaction. A phase transformation from LiY(WO₄)₂ to Li₃Y(WO₄)₂ can be obviously seen from the in situ XRD during discharge process. While Li₂Y(WO₄)₂ appears as an intermediate phase with a reverse charge reaction. In addition, in situ XRD also demonstrates that LiY(WO₄)₂ nanotubes have surprised electrochemical reversibility. All the above results indicate that LiY(WO₄)₂ nanotubes can be expected to be anode candidate for rechargeable lithium ion batteries (LIBs).